Pressure Control and Setting for Fusion 6000 High-Pressure Pump

The Chemyx Fusion 6000 High-Pressure Syringe Pump has pressure suitable for any application. To use the pressure control settings on a high-pressure syringe pump, you would need to use the pump in conjunction with the Pressure Sensor. The Pressure Sensor will plug into the pump and a 3-way connector will connect the syringe and the Pressure Sensor. The maximum pressure is 2000 PSI. Pressure control will stop the pump once the target pressure is reached.

Pressure Sensor for Fusion 6000

The PV350 will plug into the pump and a 3-way connector will connect the syringe and the PV350. The maximum pressure is 500 PSI. Pressure control will stop the pump once the target pressure is reached.

 

    Have any questions or comments about this article? Fill out the form below and we'll get back to you as soon as possible!

    Privacy & Terms

    By choosing "I agree" below you agree to Chemyx Inc Terms of Service. You Also agree to our Privacy Policy, which describes how we process your information.