Advanced Command Line

This example code allows you to run multiple steps using MATLAB. At the top of the code is the ComPort and BaudRate. Please change these values to match your pumps settings. In the advanced command line the example will ask to input a diameter of the syringe. It will then ask to input the volume, rate, and delay for the first step. It will then repeat this for the second step. After inputting all the values, the pump will start. You can pause the pump by pressing any key and hitting enter. After that you can restart the pump by pressing any key and hitting enter. Finally you can stop the pump by pressing any key and hitting enter.

    Have any questions or comments about this article? Fill out the form below and we'll get back to you as soon as possible!

    Privacy & Terms

    By choosing "I agree" below you agree to Chemyx Inc Terms of Service. You Also agree to our Privacy Policy, which describes how we process your information.