Start/Stop

At the top of the code is COMPort variable. Please change this variable to the com port the syringe pump is using. Then run the program. The code will then open the com port and set the baud rate to 9600. The pump will then start pumping until you hit any key and hit enter in the command line. This will stop the pump,

    Have any questions or comments about this article? Fill out the form below and we'll get back to you as soon as possible!

    Privacy & Terms

    By choosing "I agree" below you agree to Chemyx Inc Terms of Service. You Also agree to our Privacy Policy, which describes how we process your information.